Printomatic Support

Printomatic Support


Step 1: Charge your camera-

Plug the cable into a 1amp charge block and into your camera. Make sure the camera is laid flat on the ground and the cable is not fully extended.

Step 2: Turn your camera on-

Press and hold the power button until the lights at the bottom come on. Tip: don’t lay camera flat, hold in your hands.

Step 3: loading paper into the printer

Always load the blue sheet facing down with the gloss of the paper up. Avoid touching the paper as much as possible by holding from the sides.

Step 4: Holding the camera for a selfie-

Step 5: holding the camera for a picture-

Step 6: Take a picture-

Press the shutter button to take the picture


Inserting Photo Paper

Inserting Photo Paper Step 1
Slide the latch on the paper compartment door down to open and open the door.
Inserting Photo Paper Step 2
Slide the entire pack of ZINK paper into the paper tray. Each pack of ZINK paper
includes a blue Color Calibration Sheet. Make sure the pack is loaded with the
blue Color Calibration Sheet with the bar code facing down. The glossy side of
the paper should be facing up.
Inserting Photo Paper Step 2
Inserting Photo Paper Step 3
Close the paper compartment door.
Inserting Photo Paper Step 4
The blue Color Calibration Sheet will eject when you take your first picture, and
then your photo will print.
Inserting Photo Paper Step 4

Refilling Photo Paper

Only load a single pack of 10 papers and the corresponding blue Color Calibration Sheet in the printer at one time when the printer is empty. The Color Calibration Sheet will be processed automatically at the start of each paper pack, calibrating the printer for that specific paper.


QHow do I charge my camera?

ATo charge the battery in your camera, you will have to plug the provided micro USB cable into any wall adapter rated at 1 amp (not included). Using a computer or laptop to charge the camera is not recommended because it will significantly increase the charging time.

QCan you choose when to print or does the camera print automatically?

AYour Kodak PRINTOMATIC camera prints automatically. Every picture taken will print after a few seconds.

QIs any type of paper compatible with this camera?

AThe Kodak PRINTOMATIC was designed to work only with Kodak ZINK photo paper. Other papers may be incompatible with this camera.

QHow many sheets can I put in at once?

AYou can load one 10-pack of Kodak ZINK Photo Paper at one time. Please see the section on Inserting Photo Paper in the full user guide.

QDoes the camera's printer print pictures from other devices?

AThe Kodak PRINTOMATIC only prints the pictures you take from the camera. It does not connect to other devices.

QWhat memory cards can be used with my camera?

AThe Kodak PRINTOMATIC accepts microSD™ cards and flash memory cards from all brands.

QIs a microSD™ card required for this camera?

AA microSD™ card is not required in order to use the camera. If you want to save your photos to your computer you will need to have a microSD™ or comparable memory card in your camera while you take your pictures.

QHow do I turn on the flash for my camera?

AYour camera is equipped with a light sensor that will automatically turn on the flash in low light settings.

QHow do I put the optional accessory strap on my camera?

AThe optional strap, sold separately, comes in two pieces. First, thread the loop at the end of one of the strap pieces through the strap slot on the camera, and then thread the strap through the loop. Do this again with the second piece and second strap slot. Then thread the pointed strap end through the buckle and fastener. Adjust the strap as desired.



QWhy are the colors on my prints coming out wrong?

ATo ensure color accuracy, your camera's printer must be properly calibrated by the Blue Color Calibration Sheet inserted with the bar code facing down. This sheet has a unique barcode specific to each paper pack, so make sure not to mix paper from different packs together.

QWhat do I do if the paper is stuck?

ATurn the printer off and on again and the printer will eject the paper. Do not try to pull out the paper by hand.

QWhy are my prints coming out blank?

APlease be sure that the Kodak ZINK paper pack is properly inserted in the camera. When loading the paper, the glossy side should be facing up. Please review the paper loading instructions included in the full user guide.

QWhy are my pictures not centered?

AThe frame marks on the view finder are set to a focus target 6 feet away. If you are taking pictures less than 6 feet from your target, the frame marks may not line up with the photo.

QWhy are my pictures coming out with lines?

AMake sure that your paper is properly inserted and that nothing is obstructing the exit slot for the picture to come out. Do not aggressively shake your camera; it may interfere with the printing process.

QWhy are my prints coming out black and white?

AThe Kodak PRINTOMATIC can print pictures in color or in black and white. To change modes, push the switch next to the shutter button.


Customer Service
U.S.:, 844-516-1539
International:, 844-516-1540

The Kodak trademark, logo and trade dress are used under license from Kodak. PRINTOMATIC is a trademark of C&A IP Holdings, LLC in the U.S., the European Union and the United Kingdom. ZINK, Zero Ink, and the ZINK logo are trademarks of ZINK Holdings, LLC, registered in the U.S. and other countries. microSD is a trademark of SD-3C LLC in the U.S. and/or other countries. All other products, brand names, company names and logos are trademarks of their respective owners, used merely to identify their respective products, and are not meant to connote any sponsorship, endorsement or approval.

Legal Disclaimer: Actual product packaging and materials may contain more and different information than what is shown on our website. We recommend that you do not rely solely on the information presented and that you always read labels, warnings, and directions before using a product.

Distributed by: C&A Marketing, Inc., 114 Tived Lane East, Edison, NJ 08837 USA
C&A Marketing UK LTD, 167 Hermitage Road, Crusader Industrial Estate, London N4 1LZ, UK
©2017 All Rights Reserved.